Calcium measurement is critical for numerous biological investigations. Fluorescent probes that show spectral responses upon binding calcium have enabled researchers to investigate changes in intracellular free calcium concentrations by using fluorescence microscopy, flow cytometry, fluorescence spectroscopy and fluorescence microplate readers. Fluo-3 and Fluo-4 are most commonly used among the visible light-excitable calcium indicators. Fluo-4 is an analog of fluo-3 with the two chlorine substituents replaced by fluorines, which results in increased fluorescence excitation at 488 nm and consequently higher fluorescence signal levels.

Prepare a 2 to 5 mM AM esters stock solution in high-quality, anhydrous DMSO. Prepare a working solution of 2 to 20 μM in the buffer. For most cell lines we recommend the final concentration of calcium indicators be 4-5 uM. Probenecid or sulfinpyrazone may be added to the the dye working solution (final in well concentration will be 1-2.5 mM for probenecid, or 0.1 -0.25 mM for sulfinpyrazone) to reduce the leakage of the deesterified indicators. Add equal volume of the dye working solution into your cell plate. Incubate the plate at room temperature (20-120 minutes), then incubate the plate at room temperature for another 30 minutes. Replace the dye working solution with HHBS to remove excess probes. Run the experiments at Ex= 506nm, Em=526nm.

TD0052

C36H25Cl25N2O13

879.44

(< 1 mg/ml refers to the product slightly soluble or insoluble )
Powder: -20°C for 3 years
In solvent: -80°C for 2 years