Crenolanib is a potent and selective inhibitor of wild-type and mutant isoforms of the class IIIreceptor tyrosine kinasesFLT3andPDGFRα/βwithK_ds of 0.74 nM and 2.1 nM/3.2 nM, respectively.

Crenolanib has 25-fold more affinity for PDGFRA/B compared with KIT, and is approximately 135-fold more potent than STI571 for inhibiting the PDGFRA D842V mutation. The IC₅₀for crenolanib for a KIT exon 11 deletion mutant kinase is greater than 1,000 versus 8 nM for STI571. Crenolanib has low nanomolar potency against the V561D + D842V-mutant kinase that is similar to its potency against the isolated D842V mutation. Both STI571 and crenolanib potently inhibit the kinase activity of the fusion oncogene with IC₅₀values of 1 and 21 nM, respectively, and inhibits PDGFRA activation in this cell line with IC₅₀values of 93 and 26 nM, respectively^[1]. HL60/VCR and K562/ABCB1 cells, overexpressing ABCB1, are 6.9- and 3.6-fold resistant to crenolanib, respectively, in relation to parental HL60 and K562 cells. PSC-833 fully reverses resistance to crenolanib in both HL60/VCR and K562/ABCB1 cells. Crenolanib (1 nM-10 μM) stimulates ABCB1 ATPase activity in a concentration-dependent manner. Crenolanib treatment does not increase the cell surface expression of ABCB₁. Crenolanib inhibits [¹²⁵I]-IAAP photocrosslinking of ABCB1 at high concentrations, with 50 % inhibition at 10 μM, but has little effect at lower concentrations, below 1 μM^[2]. Crenolanib decreases NSCLC cell viability, induces apoptosis in NSCLC cells, and inhibits cell migration in NSCLC cells^[3].

Crenolanib (10 mg/kg and 20 mg/kg) suppresses non-small-cell lung cancer tumor growth in vivo and induces tumor cell apoptosis, and the dosage of crenolanib applied is well tolerated by recipient mice^[3].

443.54

Solid

C₂₆H₂₉N₅O₂

670220-88-9

Room temperature in continental US; may vary elsewhere.

DMSO : 25 mg/mL(56.36 mM;ultrasonic and warming and heat to 60℃)

请根据产品在不同溶剂中的溶解度选择合适的溶剂配制储备液；一旦配成溶液，请分装保存，避免反复冻融造成的产品失效。
储备液的保存方式和期限：-80℃, 6 months; -20℃, 1 month。-80℃ 储存时，请在 6 个月内使用，-20℃ 储存时，请在 1 个月内使用。

请根据您的实验动物和给药方式选择适当的溶解方案。以下溶解方案都请先按照In Vitro方式配制澄清的储备液，再依次添加助溶剂：

——为保证实验结果的可靠性，澄清的储备液可以根据储存条件，适当保存；体内实验的工作液，建议您现用现配，当天使用； 以下溶剂前显示的百
分比是指该溶剂在您配制终溶液中的体积占比；如在配制过程中出现沉淀、析出现象，可以通过加热和/或超声的方式助溶

• 1.

  请依序添加每种溶剂： 10% DMSO    90%corn oil

  Solubility: ≥ 3 mg/mL (6.76 mM); Clear solution

  此方案可获得 ≥ 3 mg/mL (6.76 mM，饱和度未知) 的澄清溶液，此方案不适用于实验周期在半个月以上的实验。

  以 1 mL 工作液为例，取 100 μL 30.0 mg/mL 的澄清 DMSO 储备液加到 900 μL玉米油中，混合均匀。

• 2.

  请依序添加每种溶剂： 10% DMSO    40%PEG300   5%Tween-80   45% saline

  Solubility: ≥ 1.43 mg/mL (3.22 mM); Clear solution

  此方案可获得 ≥ 1.43 mg/mL (3.22 mM，饱和度未知) 的澄清溶液。

  以 1 mL 工作液为例，取 100 μL 14.3 mg/mL 的澄清 DMSO 储备液加到 400 μL PEG300 中，混合均匀；向上述体系中加入50 μL Tween-80，混合均匀；然后继续加入 450 μL生理盐水定容至 1 mL。

  将 0.9 g 氯化钠，完全溶解于 100 mL ddH2O 中，得到澄清透明的生理盐水溶液
• 3.

  请依序添加每种溶剂： 10% DMSO    90% (20%SBE-β-CDin saline)

  Solubility: ≥ 1.43 mg/mL (3.22 mM); Clear solution

  此方案可获得 ≥ 1.43 mg/mL (3.22 mM，饱和度未知) 的澄清溶液。

  以 1 mL 工作液为例，取 100 μL 14.3 mg/mL 的澄清 DMSO 储备液加到 900 μL20% 的 SBE-β-CD 生理盐水水溶液中，混合均匀。

  将 2 g 磺丁基醚 β-环糊精加入 5 mL 生理盐水中，再用生理盐水定容至 10 mL，完全溶解，澄清透明